INDUSTRIES WE SERVE
Every sector brings its own materials, tolerances and cycle times. These are the industries our machines run in every day.
High-volume, repeatable joints on coated and high-strength sheet.
Coated steels need tight current control and frequent electrode dressing — MFDC machines hold the weld window across long runs.
Clean, invisible welds on thin stainless and galvanised housings.
Visible surfaces cannot show indentation, so electrode force and hold time matter as much as current.
Tube and profile joints that stay square through paint and assembly.
Mixed tube wall thicknesses need flexible arm geometry and repeatable positioning fixtures.
Heavy-current mesh and grating lines for structural products.
Cross-wire welds must meet minimum shear strength per EN 10080 — machines are sized for the bar diameter, not the sheet.
Job-shop flexibility across changing parts and short runs.
Short runs favour microprocessor control with stored programs so operators can switch parts in seconds.
Leak-tight seam welding on stainless vessels and sinks.
Stainless has high resistivity and low conductivity — lower current, shorter time, and careful heat control prevent carbide precipitation.
YOUR SECTOR NOT LISTED?
If you weld sheet, bar, mesh or fasteners, we can almost certainly build for it. Tell us about your part.